MAINTENANCE PLANS FOR YOUR OIL HEATING SYSTEMS

We service & install many major brands of heating systems to accommodate all residences and budgets. This includes furnaces, boilers, ductless mini-splits, and heat pumps.

Regular furnace cleaning and maintenance help prevent frequent failures, inefficient performance, and poor indoor air quality. Hillside Heating & Cooling is the leading furnace cleaning and maintenance specialist in New Castle County, DE, Cecil County, MD, and Southern Chester County, PA. Schedule our  30-point Furnace Tune-Up designed to prevent heating problems this season.

If replacement of heating equipment becomes necessary, or the customer decides to upgrade heating equipment, Hillside Oil Heating & Cooling will credit the amount of this maintenance plan toward a replacement installation performed by Hillside.

Heating Maintenance Plan

Heater Tune-Up Includes the Following:

• Replace nozzle one oil filter, and pump strainer
• Clean, lubricate, and adjust burner, inspect all controls and adjust if needed
• Vacuum and clean the boiler or furnace, smoke pipe, and base of the chimney (Where needed and accessible)
• Inspect and clean combustion chamber – Oil circulating pump or fan motor and bearings
• Clean and adjust electrode and high-tension leads
• Check the pump, examine belts, pulleys, and couplings

Warm Air Systems:

Percentage of coverage based on the plan for parts and labor associated with repairs or replacements of defective parts (as listed below) due to normal wear and tear for one year from the date of acceptance. Parts not specifically listed are not covered. If replacement of equipment becomes necessary or the customer decides to upgrade, Hillside will credit the amount of this maintenance plan toward a replacement performed by Hillside. The customer must call and schedule an annual tune-up to keep the furnace in operating condition.

Download Hillside’s Heating Maintenance Plan

• Electrodes Nozzle
• Pump strainer
• Fan & limit control
• High tension lead
• Oil burner motor
• Draft regulator
• Combustion Chamber
• 1 Thermostat (Plain)
• Drive Couplings
• Smoke pipe-10’
• Shaft/bearings
• Transformer
• Fuel oil pump
• Fuel oil filter
• Primary relay
• Burner fan
• Blower motor
• Blower belt

Hot Water (Boiler)  Systems:

All parts covered in warm air system plus: Feed Valve, Relief Valve, Aquastat, Circulator Motor, Drive & Bearing Assembly. An extra $20.00 is charged for each additional circulator.